Once the camera is successfully attached to the swivel clip (Figure F), plug the other end of the cable into a wall adapter (not provided), then plug the adapter into the wall outlet (Figure D)ĥ. Wth the Micro-USB cable connected, gently attach the camera to the swivel dip following the “Using Swivel air instructions on the bottom of page 5. Once the table stand is fully assembled, plug the Micro-USB connector end of the supplied USB cable into the charging port of the camera (figure B)ģ. To charge Cop Carr using a wall outlet, start by assembling the table stand following instructions on the top of page 5.Ģ. When charging is complete, the indicator light will turn OFFġ. NOTE: if Cop Cam^ is charging in your computer/laptop, it will ONLY charge NOT recordģ. While the camera is charging in your computer/laptop, the indicator light will be alternately flashing red and green. NOTE: USB port may be located either on the left or right side of your computer/laptopĢ. To charge Cop Cam using your computer/laptop, plug the Micro-USE connector end of the supplied USB cable into the charging port of the camera (figure B) Once the Micro-USE cable is plugged into the Cop Cam-, plug the other end of the cable into the USE port of your computer / laptop (figure C) NOTE: When the indicator light starts to flash red every 1 second, the battery has 1D16 charge remaining until plugged into a power source.ġ. When the indicator light begins to flash red every 1 second, the battery is low. To check the battery, turn Cop Cam- ON by pressing and holding the POWER/RECORD button for 4 seconds (Figure A), Indicator light is solid red when fully charged.Do not expose to temperatures below 32’F or above 104F.Do not immerse in water or other liquids.Do not place outdoors unless protected.Cop Cam- is not waterproof, do not expose to wet or damp environments.Clean the camera lens only with a soft cloth_.Keep away from strong magnets and high voltage.To protext the Cop Cam and recordings from damage: Please review the state and local laws of your jurisdiction regarding using video recording devices.IMPORTANT SAFETY INSTRUCTIONS, READ AND FOLLOW ALL WARNINGS AND INSTRUCTIONS BEFORE USING THIS PRODUCT. LED light will alternately flash red and green. STEP 4: To charge Cop Cam”‘, plug into computer/laptop. (Figure C) Use included USB cable to connect Cop Cam”‘ to your Computer/Laptop. STEP 3: To retrieve footage, remove memory card by pressing inward to release, then pull out of slot. To take a photo quickly press the POWER/RECORD button once. STEP 2: To switch to photo mode press and hold the POWER/ RECORD button for 2 seconds.
0 kommentar(er)
